Intermec PB50 Manuale Utente Scaricare il pdf (Pagina 44)

Chapter 2 — Configuring the PB50

34 PB50 Mobile Label and Receipt Printer User’s Guide

To configure the printer to use WEP authentication

1 Send the following commands to login as an admin and set the

SSID:

run"su -p pass admin"

setup write "wlan","uart1:"

setup "wlan","SSID","xxxxx"

where xxxxx can be from 0 to 32 ASCII characters, not including

the double quote.

2 Send the following commands to configure the WEP keys. The

following example sets WEP key 1 to 1234 and enables WEP key 1.

setup "wlan","WEP1","0x0001020304"

setup "wlan",".WEP_KEY","1"

setup "wlan","ACTIVE","1"

setup write "wlan","uart1:"

To configure the printer to use WPA-PSK or WPA2-PSK mode

1 Send the following commands to login as an admin and set the

SSID:

run"su-p pass admin"

setup write "wlan","uart1:"

setup "wlan","SSID","xxxxx"

where xxxxx can be from 0 to 32 alphanumeric characters.

2 Send one of the following WPA/WPA2 ON commands to turn on

WPA or WPA2 authentication. Send the WPA-PSK or WPA2-PSK

command to set a pre-shared key:

setup "wlan","WPA","ON"

setup "wlan","WPA2","ON"

setup "wlan","WPA_PSK","xxxxxxxxxx"

setup "wlan","ACTIVE","1"

setup write "wlan","uart1:"

where xxxxxxxxxx is a value between 8 and 64 characters.

To configure the PB50 to use WPA or WPA2 Enterprise mode

1 Send the following commands to login as an admin and set the

SSID:

Note: The default password for logging in as an admin is “pass.”

If you have changed the password, you will need to use your

password instead of “pass.”

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 71 72

Nessun commento

Intermec PB50 Manuale Utente Pagina 44